Internacional Finish - 1 Quart by Sparks Southwest Save Liquid error (product-badge line 32): -Infinity% $15.99 1 2 3 4 5 6 7 8 9 10+ Quantity Quantity Add to cart Internacional Finish Cannot Ship to California. A waterborne finish and polish for use over all flooring surfaces including sealed concrete and wood. A Maintenance Floor FinishInternacional Finish is a waterborne maintenance coating designed to impart a gloss appearance. Used to overcoat sealed surfaces and finished woods to impart a surface that is not only beautiful, but scratch, mar and scuff resistant. Simplifies maintenance. Internacional Finish is designed to minimize the need for stripping. Simply recoat worn dull areas. Internacional Finish will blend with prior coatings. Proper maintenance of Internacional Finish will eliminate the need to reapply sealers due to wear. Most Porcelain Tile and glazed Ceramic Tile may be coated with Internacional Finish to give a glossy appearance. Note that you do not use any “sealer” on these tiles. Grout lines must be sealed. (S.P.S.) Characteristics: High glossEasily maintainableHard surface resists dirt penetrationEasy cleanupBlends in with prior coatsEasy applicationNon flammableLow odorFast dryingSpray Buff and BurnishableLabor savingDetergent resistantNo ethylene glycolsScuff, scratch & mar resistantUses:All types of flooring with the exception of unsealed porous surfaces such as bare concrete, unfinished wood, etc.. Not intended for use over glazed ceramics or outdoors. Directions for Use:Surface must be clean and dry. Apply thin coats using a clean mop or wax applicator. Can also be applied by hand with a foam rubber brush. Do not allow to puddle. Apply so that no white of the polish is visible. allow 30 minutes between coats. 2 to 3 thin coats recommended. Technical Information:Appearance: Milky white; dries clear pH: 8.5 Low V.O.C. Charge: Anionic Coverage: Approx. 1000 sq ft/gal Freeze/Thaw: Protect product from freezing Temperature window: 50°-90° F. (10° C) Min. Internacional Finish over Mex Seal: On a fresh coat of Mex Seal, the sealer, by nature tries to repel other liquids especially water and waterborne coatings. In order to ensure the Internacional Finsh adheres properly to a fresh coat of Mex Seal, a light buffing is required before application. If Mex Seal is left alone for a few weeks, then cleaned, this too will condition the surface so that the finish can take properly to the Mex Seal.