Lime Fine Plaster by Otterbein Save Liquid error (product-badge line 32): -Infinity% $24.00 1 2 3 4 5 6 7 8 9 10+ Quantity Quantity Add to cart Calcea® Lime Fine Plaster Technical Data Product Brochure Spreading Rate with a plaster application of 3 mm approx. 6.75 m2 each 25 kg bag Water Consumption approx. 8 l each bag Weight 25kg Composition CALCEA® fine lime plaster consists of natural hydraulic lime acc. to EN 459-1 and light-coloured marble sands. Properties • free of cement • suitable for allergy sufferrers • highly permeable • moisture- and climate regulating • exclusively consists of natural raw materials • low-tension hardening process • no mold formation due to high alkalinity • designable in many ways Application In the interior and exterior, in particular in biological, ecological building as well as cultural heritage protection. Excellently suitable as finishing plaster for CALCEA® lime priming plaster and all mineral priming plasters. If CALCEA® fine lime plaster shall be used in exterior areas, please contact our technical consultants. In principle, a final coating with CALCEA® lime paint, CALCEA® lime full-tone paint or CALCEA® lime slurries is required for outdoor use. Plaster substrate The plaster substrate must be dry, clean and free from loosely attached particles. Always carry out plaster substrate test according to VOB/C and DIN 18350. Processing Processing by hand as well as with all common plaster machines. CALCEA® fine lime plaster is applied with a steel trowel on the covering the complete surface. The mortar applied can be structured or felting or smoothing in a fresh condition using a scoop, trowel or spatula. Special notes Protect fresh plaster against fast drying-up. The air and surface temperature must be at least 5 ° C and maximum 25 ° C. CALCEA® fine lime plaster shall only be used in the original state without additives. Storage Dry, if possible on wooden shelves and protected against draft. Technical data Mortar group: CS I acc. to EN 998-1 PIc acc. to DIN 18550 Fire Class: A1 Grain size: 0 - 0.6 mm Solid mortar raw density: 1.40 kg/dm3 Compressive strength 28 days: approx. 1.0 N/mm2 E-Module: approx. 1400 N/mm2 Water vapour diffusion resistance factor µ: < 8 Water absorption: W0 Safety instructions Mortal will react very alkaline with water, thus: Protect skin and eyes, rinse thoroughly with water in case of contact, immediately contact doctor in case of eye contact. Quality-monitored production CALCEA® fine lime plaster is continuously tested in our plant laboratory within the scope of our in-house monitoring with respect to the fulfilment of composition and properties. This will ensure a uniform quality of the product. CALCEA® fine lime plaster has the quality certificate „RAL plant dry mortar“ and is certified acc. to EN 998-1.