PC-MASONRY - Concrete and masonry filler for vertical applications
PC-MASONRY - A Concrete and masonry filler for vertical applications
PC-Masonry ™ Paste Epoxy is the concrete and masonry filler for applications that are vertical, inclined or overhead. No drip or sag. Gray color resembles cinder block. Easy to trowel. Long open time. Anti skid finish when cured.
- Repair large voids and trip hazards in concrete
- Level out uneven spots in concrete
- Rebuild and patch vertical damage
- Rebuild missing pieces on steps and curbs
- Coat concrete areas to become skid resistant on decks and pools
- Seal and rebuild spalled concrete flooring
- Deter equipment damage to concrete flooring
- Repair damaged dormitory wall
- Fill spalled concrete in parking garage ramp
- Reduce trip hazard in public park walkway
- Seal pipe hole through exterior wall
- Waterproof cracked cinderblock
- Fix damage to wall from fork truck
- Secure landscape block or stone
- Repair holes to faux or imitation stone sign
- Repair damaged stucco on hotel or restaurant
- Fill hole in wall from swinging delivery door
- Fill and repair broken concrete statue or fountain
How to prepare a surface for bonding with PC-Masonry™
Old concrete must be clean and profiled or textured. Surface must be clean and sound. It may be dry or damp, but free of standing water. Remove contaminants such as dust, dirt, oil and grime with a solvents such as denatured alcohol (ethanol), acetone, rubbing alcohol (isopropyl alcohol) or lacquer thinner. Mild detergent solution in water is also good removing contaminants. Use a clean paper towel or rag for wiping. Do not use mineral spirits or paint thinner for removing contaminants. New concrete should be a minimum of 21 days old. Prepare the surface by rough-grinding, scarifying or by using other equipment that will give a roughened profile. A roughened surface is imperative for good adhesion. Always be sure the bonding surfaces are prepared in advance before mixing product. Mix only enough PC-Masonry that can be used within 20 minutes at 75 °F (24 °C). Remove rust and loose paint with sandpaper or wire brush. Epoxy typically sticks to most paints. If there is a concern of the paint’s adhesion then remove it with sandpaper or wire brush. Smooth, glossy and shiny surfaces should be roughened using sandpaper to increase adhesion.