Injection Grout/Mortar 5 by Otterbein Save Liquid error (product-badge line 32): Computation results in '-Infinity'% $79.50 55 Lb Bag - $79.50 1 Gallon Bucket - $32.50 Size 55 Lb Bag 1 Gallon Bucket 1 2 3 4 5 6 7 8 9 10+ Quantity Quantity Add to cart Special lime mortar based on natural hydraulic lime for filling cavities, filling cracks and joints with a caulking gun or injection pump and for strengthening natural stone and clinker masonry indoors and outdoors, especially for objects relevant to monument preservation. HISTOCAL ® injection mortar - M5 - consists of natural hydraulic lime (NHL) according to EN 459-1, pozzolan, grain graded crushed lime sand and additives and is a purely lime-bound, cement-free product. HISTOCAL ® injection mortar – M 5 – is suitable for filling cracks and cavities , particularly in historical buildings and when renovating masonry. It impresses with its soft, plastic consistency , is pumpable and pressure-resistant . Technical DataProduct Brochure Spreading Rate 21 l wet mortar each 25 kg (55lb) bag Water Consumption approx. 0.33 l/kg Composition HISTOCAL® Injection mortar – M5 consists of natural hydraulic lime NHL 5 acc. to EN 459-1, Puzzolan, grain-classified crushed lime sands and improvement additives. Properties • free of cement • soft, plastic consistency • lime-bound • suitable for pumping • pressure-stable Application HISTOCAL® Injection mortar – M5 is suitable for the filling of cracks and hollow spaces, in particular at historic monuments and for masonry renovation. Substrate The substrate must be clean and free from loosely attached particles. A sufficient preliminary wetting is compulsory. Special notes Protect fresh mortar against fast drying-up. The air and surface temperature must be at least 5 ° C and maximum 25 ° C. HISTOCAL® Injection mortar – M5 shall only be used in the original state without additives. Storage Dry, if possible on wooden shelves and protected against draft. Technical data Mortar group: M5 acc. to EN 998-2 Fire Class: A1 Compressive strength after 28 d: >5N/mm2 expected compressive strength after 56 d: >10 N/mm² Solid mortar density: 1.45 kg/dm³. Largest grain size: < 0.7 mm Water absorption: W0 Safety instructions Mortal will react very alkaline with water, thus: Protect skin and eyes, rinse thoroughly with water in case of contact, immediately contact doctor in case of eye contact. Quality-monitored production HISTOCAL® Injection mortar – M5 is continuously tested in our plant laboratory within the scope of our in-house monitoring with respect to the fulfilment of composition and properties. This will ensure a uniform quality of the product.